Ultra electronics MAGICARD 300plus User Manual download pdf (Page 37)

Ultra Electronics Card Systems Quick Start Guide

MAGICARD Color Printer Page 37

4. Whilst changing the dye film, and with the dye film removed, gently wipe the tip of the

Thermal Printhead, using a gentle side-to-side action, with the Felt Tip Cleaning Pen

supplied.

5. Using a tissue, remove any deposits from the pen tip and replace the pen cap to avoid

solvent evaporation. Allow the solvent to evaporate fully from the printhead before

proceeding to fit the new roll of dye film.

Cleaning the Tacky Roller

NOTE - It is very important that these Cleaning Instructions are adhered to in order to

maintain the MagiCard print quality.

A Tacky Roller is located between the Cassette and the upper brushstrip. Its purpose is to

pick up loose debris, fibres and particles from the upper surface of each card which would

otherwise cause a blemish on the finished printed card. Depending on the type of cards used

it is recommended that the Tacky Roller is cleaned each time the Card Cassette is filled, to

recover its stickiness. Clean the Tacky Roller using a piece of Scotch adhesive tape. Refer to

Section E to see how to remove the Tacky Roller.

Cleaning the Rubber Rollers

It is recommended that the Rubber Rollers in the transport mechanism be cleaned after every

1000 cards printed, using the recommended solvent-impregnated Cleaning Card as follows:

CAUTION: Failure to clean the Rubber Rollers may result in mis-registration of images

and problems in feeding cards out of the Cassette.

WARNING The recommended cleaning materials are inflammable. Clean the Thermal

Printhead in a well-ventilated area and avoid naked flames. Extinguish any cigarettes.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44 45

No comments

Ultra electronics MAGICARD 300plus User Manual Page 37